Start-Up - TLS M100 Blue Mode D'emploi

Instruction manual
Please observe the safety information of the enclosed information sheet.

Start-up

In order to put the products into operation properly, read this instruction manual, including the safety information,
fully and carefully before use. The products should only be operated on a stable, even surface. Particular care
should be taken to ensure safe installation when using speaker stands. Observe the instruction manual for the
speaker stand used. Connected cables should be laid safely here (Caution! Trip hazards).
- Turn the TONE control or Bass Treble (depending on the device) to the centre position.
- Turn the VOLUME control (MIC, CD or TAPE) to the min. position.
- Plug the accompanying power cable into the power supply connector on the side.
- Connect the mains plug to the 230 V~/50 Hz power supply.
- Switch the TLS devices on or off using the POWER switch.
®
- The switch is located above the power cable input on the side of the enclosure.
31