Euroflex monster IS 56 HS Manuel D'instructions page 9

All manuals and user guides at all-guides.com
• Fill Iron according to the "Filling the Water Tank/Boiler" section of
instructions.
• Turn on the Power Switch - Power Indicator Light on Power Switch
and Iron Indicator Light on Iron will illuminate.
• When (green) Steam Indicator Light illuminates, and Iron Indicator
Light goes off*, steam is ready - usually within 5 to 7 minutes.
• Hang garment on a hanger and hold the fabric from the bottom of
the garment - slightly taut, with one hand.
• Holding the Iron in a vertical position, hold down the Steam Button
while moving the Iron from the top of the garment to the bottom.
If Iron is left on without steaming for a time, water can condense in
the hose and droplets of water can be seen when you begin to use
the Steam Generator Iron again.
For best results, aim the Iron away from yourself, other people,
animals and clothing and press the Steam Button for a few seconds
to remove the condensation and allow steam to fill the hose again.
7 Filling Boiler While In Use
CAUTION: Never unscrew Water Tank Cap while iron is producing
steam and Boiler is under pressure.
• Before opening Water Tank/Boiler, ensure that there is no steam
inside. To do this, hold down the Steam Button until no more
steam appears.
• Turn the Iron off (see "Turning On and Off" section).
• Unplug Iron from outlet.
• Slowly unscrew the Water Tank Cap just enough to let any excess
steam escape.
• Using Funnel provided, fill with water – no higher than base of
Water Tank Cap thread. If water spills over, wipe up with cloth.
• Replace Water Tank Cap and screw it on tightly. Do not over-
tighten, as this can damage the O-ring.
• Plug Iron back into electrical outlet.
9
Using Your Iron