Euroflex monster IS 56 HS Manuel D'instructions page 7

All manuals and user guides at all-guides.com
• Turn on the Power Switch - Power Indicator Light on Power Switch
and Iron Indicator Light on Iron will illuminate.
• When the (green) Steam Indicator Light illuminates, and the Iron
Indicator Light goes off, you can begin ironing - usually within 7-9
minutes (the exception to this, is the first operation of your iron, or
after cleaning the boiler).
Turning Off
• After Ironing, turn off the Power Switch.
• Set the Temperature Control to OFF.
• Unplug appliance and let cool completely before putting away.
• Secure the iron using the Iron Belt.
• Store Iron in flat, horizontal position - never resting on its heel.
4
Steam Ironing
Never iron or steam clothing while it is being worn!
• When using the Steam Generator Iron for the first time, set the Tem-
perature Control to the "Nylon" setting. Wait five (5) minutes, then
press the Steam Button repeatedly until water drops appear on
Soleplate. Let some water circulate through the hose and come
out the tip of the Soleplate. Wipe off Soleplate with clean cloth.
• Set Temperature Control to the desired "steam"
setting – between "Wool" (••) and "Linen" (•••)
on the Temperature Control (shaded area).
NOTE: To "Steam Iron", always set the Temperature
Control in the "steam" range – between "Wool" (••)
and "Linen" (•••). If set below the "Wool" setting,
the temperature will be too low causing the steam
to condense and consequently, water may drip
from the Soleplate.
• As soon as the (green) Steam Indicator Light on the Boiler illumi-
nates and the (red) Iron Indicator Light on the Iron goes off, the
Steam Generator Iron is ready to use. Push the Steam Button on the
Iron to begin using steam.
NOTE: The Iron Indicator Light on the Iron and Steam Indicator Light on the
Boiler will cycle on and off while Iron is in use. This is normal, as the tem-
perature is being regulated. The unit is still "on" when these lights go out.
• Each time you start ironing, or after an interruption, hold Iron
toward the floor and push the Steam Button to clear steam from
the Iron and prevent fabric staining.
Continued on next page
Using Your Iron
7