miniland baby digimonitor 8 plus Mode D'emploi page 34

Channel linking:
This product is designed to allow monitoring different areas with up to 4 cameras
(Channel 1, 2, 3 or 4 assigned to different cameras). The original monitor and camera
are already set on Channel 1 by manufacturer at factory. If you need to add extra new
camera for monitoring, you need to choose a new channel to 'link' the new camera with
existing monitor.
- Plug the USB receiver into the monitor (photo frame). Turn OFF the camera.
Place them not more than 2 feet apart.
- Choose your preferred channel by pressing Chanel selection button (3) in the USB
receiver. Press and hold on the Channel selection button until the red LED starts
blinking.
- Then turn ON the camera. Keep pushing the hidden Linking button (10) through the
small hole at the back of the camera by using a pin. The Power LED Light will start
flashing indicating the linking process; linking between the camera and the monitor
unit is undergoing.
- Linking is successful when your live image can be seen on the monitor screen.
At this moment the power LED on the Camera stops flashing and the camera unit and
the monitor unit work well together.
- Repeat the above process to connect additional cameras (up to 4 cameras).
4
Channel Scan
This product enables you to use up to 4 different cameras with the same Intercom
continuously monitoring different areas.
Press Channel button (3) USB Reciber. Automatic scanning function is after channel 4.
The Intercom will remain in each channel for 5 seconds before automatically switching
to the next one & repeating the cycle continually.
To stop Scan function, press Channel button (3) again to return to specific channel
number with corresponding camera.
All manuals and user guides at all-guides.com
1 2
5
34
English
2
3
6