EUROM SL20 Cube Manuel D'utilisation page 9

All manuals and user guides at all-guides.com
4. Connect the quick coupling and the spray head with the hose.
5. Connect the quick coupling to the water inlet hose and the corresponding nipple
to the tap.
6. Your reel is now fully installed and can rotate around 180°.
Use
Rolling hose in and out
This reel system has been equipped with a special stop-when-you-like system.
Pull the hose to the desired length: when you stop pulling, the hose will lock
automatically. A sharp pull on the hose will then trigger the Automatic-Return-
System to roll the hose up automatically. You can interrupt this by pulling on the
hose once again. When rolling the hose in, keep the spray head in one hand (so
that it cannot flail around) and guide the hose with your other hand. The SL20 Cube
also has a Safe-Return-System which rolls up the hose more slowly (and more
safely).
If the hose is beginning to kink, pull the entire length out of the housing, remove
the kinks and allow the hose to smoothly roll back into the reel.
Operation
Connect the water supply hose to the tap. If you now open the tap, water will flow
to the nozzle and you can start spraying. Ensure that the nozzle is open! You can
regulate the flow by twisting the nozzle.
If desired, you can attach a different nozzle or an extra length of hose to the quick-
coupling between the hose and the nozzle. Lengthening the hose does result in a
drop in pressure!
Close the tap after every use and then open the nozzle for a short time in order to
release the water pressure.
9