RX4
9 Garantie et informations de dépannage
Digitrax guarantees the RX4 to be free from manufacturing defects for five years from the date of
purchase. These units are not user serviceable. If a defect occurs, return the unit to Digitrax for service.
Digitrax will repair or replace your RX4 at our discretion at no charge to you for one year from
purchase date. This warranty excludes damage due to abuse, such as failure to properly protect against
input over current with a fuse or circuit breaker or applying excessive input voltage to the unit.
Digitrax will make non-warranty repairs needed because of physical damage or electrical abuse at fair
and reasonable rates. All warranties on Digitrax products are limited to refund of purchase price or
repair or replacement of Digitrax products at the sole discretion of Digitrax. In the event that Digitrax
products are not installed or used in accordance with the manufacturer's specifications, any and all
warranties either expressed or implied are void. Except to the extent expressly stated in this section,
there are no warranties, express or implied, including but not limited to any warranties of
merchantability or fitness for a particular purpose.
Digitrax, Inc. reserves the right to make changes in design and specifications and/or to make additions
or improvements in its products without imposing any obligations upon itself to install these changes,
additions or improvements on products previously manufactured.
10 FCC Information
Radio or TV Interference: (this information is MANDATED by the FCC) This equipment has been
tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a residential environment. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and the receiver.
3. Connect the equipment into an outlet on a circuit different form that to which the receiver is
connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Note that any modifications to the equipment not expressly approved by Digitrax voids the user's
authority to operate under and be in compliance with CFR 47 rules, as administered by the Federal
Communication Commission. Digitrax believes any conscientiously installed equipment following
guidelines in this manual would be unlikely to experience RFI problems.
collin
Page 13
10/04/2013