EKVIP GATE LAMP POST Traduction Des Instructions D'origine page 12

EN
6. Insert a light source with the maximum
output specified on the lamp.
FIG. 7
7. Fit the cover.
FIG. 8
8. Fit the lamp on the screws in the
underlayer.
FIG. 9
9. Connect the power supply.
FIG. 10
MAINTENANCE
NOTE:
Switch off the power supply before
maintenance.
1. Disconnect the power supply to the lamp.
2. Wipe the lamp with a dry or slightly damp
cloth.
3. Wait until the lamp is completely dry
before switching the power supply on
again.
NOTE:
Do not use detergent, alcohol, solvent or the
equivalent to clean.
REPLACING THE LIGHT SOURCE
NOTE:
Switch off and allow the light source to cool
before replacing.
1. Disconnect the power supply.
2. Unscrew the cover.
3. Carefully unscrew the cool light source.
4. Carefully insert the new light source.
5. Screw the cover back on before switching
on the light source.
12