EKVIP GATE LAMP POST Traduction Des Instructions D'origine page 11

SAFETY INSTRUCTIONS
• Only intended for outdoor use.
• The electrical installation must comply
with local regulations. Consult an
authorised electrician if in doubt.
• Always follow the electrical specifications
on the product labelling.
• Always disconnect the power supply before
installation, connection and service.
• Never modify the product, this could result
in serious personal injury and/or material
damage, and will invalidate the warranty.
• The product must be connected to an
earthed power supply on installation.
• Do not use the product without the glass
cover.
• The product gets very hot when it is
switched on. Do not touch the product
with bare hands.
• Switch off and allow the product to cool
before replacing the light source.
ELECTRICAL SAFETY!
New installations and extensions to existing
systems must always be carried out by
an authorised electrician. If you have the
necessary experience and knowledge
(otherwise contact an electrician), you can
replace power switches and wall sockets,
fit plugs, extension cords and light sockets.
Incorrect installation can result in fatal injury
and the risk of fire.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
Warning! Do not use the
product if the glass cover is
damaged, replace it.
TECHNICAL DATA
Rated voltage
Max permitted output of light source
Socket
Protection rating
Size
DESCRIPTION
For outdoor use with fixture of powder-coated
aluminium and glass window. Includes
assembly screws. Light source sold separately.
ASSEMBLY
1. Switch off the power supply before
installation.
FIG. 1
2. Measure out the two drill holes on the
underlayer where the lamp is to be
installed.
FIG. 2
3. Drill the two holes. Tap the plugs in the
holes.
FIG. 3
4. Fit the bracket with the screws.
FIG. 4
5. Connect the wires to the terminals as
shown. The casing must be connected to
earth.
Phase conductor (L) – Black or brown
Earth conductor ( ) – Yellow/green
Neutral conductor (N) – Blue
FIG. 5
FIG. 6
EN
230 V ~ 50 Hz
60 W
E27
IP44
H 37 x Ø 18.5 cm
11