Lacor 383713 Conseils D'utilisation Et D'entretien page 55

When there is no power the juicer:
1.- Check if the power cord is properly
plugged in.
2.- Check if the drum lid and the juicing bowl
are properly assembled
3.- Check if the top-set and the base are
properly assembled.
4.- Juicer willnot operate if parts are not
assembled properly.
Low juicer yield:
1.- Different ingredients hold different amounts
of fluid that will yield different amounts of
juice.
2.- If the ingredients are not fresh, the may
contain reduced amounts of fluid, which
will yield less juice.
3.- Check if the compresson silicone is firmly
inserted.
4.- If the ingredient itself has low water
content, it may help to soak it in water
before juicing.
5.- If juicing ingredients with small seeds, after
a few servings, it may reduce the juice
yield. For best result, disassemble and
wash the top-set in between juicing.
6.- If there is seed residue on the bottom of
the strainer, this can affect juicer
performance and the overall juice yield.
There is too much pulp in the juice:
1.- When continuously juicing, and depending
on the ingredient, the juice may contain a
lot of fine pulp.
2.- To reduce the fine pulp, clean the top-set
frequently and extract the pulp.
3.- Use a mesh strainer and put the juice
through it to collect the unwanted pulp.
4.- If the strainer and the screw are damaged
and affecting the juicer´s performance, it is
recommended the parts be replaced.
The lifetime of each part may vary
depending on length and method of
use and ingredients extracted.
5.- If too many ingredients are inserted at the
same time, it may cause the juicer to stop
frequently. This can lead to pulpy juice.
Insert the ingredients slowly and few at a
time.
SOLVING PROBLEMS
The drum lid will not close:
1.- Make sure the juicing screws is pushed all
the way in to the strainer in order for the
drum lid to close properly.
2.- If the juicing screw is not properly in
position, the drum lid may not close.
Odd noise from the juicer:
1.- Check if the parts are assembled correctly.
Try reassembling the parts and listen for
the odd noise.
2.- Do not start the juicer unless there are
ingredients and/or liquid in it.
3.- Operating the juicer without ingredients
can cause damage to the screw.
4.- If the juicer is operated without ingredients
or liquid, the noise level can increase and
also can lead to damage.
5.- The friction noise from the juicing screw
and the strainer will disappear when
ingredients are inserted into the juicer.
6.- If the noise occurs when ingredients are
inserted into the juicer, check the size of
the ingredients. Do not insert anything
over 1 inch in thickness.
7.- Depending on the type of ingredients, the
dimensions can be smaller.
8.- The noise can occur if the juicer is
operated on an uneven or slanted surface.
Place the juicer on a horizontally flat
surface when operating.
The extracted pulp is very moist:
1.- During the very beginning of extraction,
the pulp can be more moist.
2.- Depending on the ingredient's condition,
the extracted pulp can be aff ected;
especially when the ingredient is not fresh,
the juice can be extracted with the pulp.
During operation, the juicing bowl shakes:
1.- The juicing screw and the strainer are set
up to crush and squeeze the ingredients.
It is normal for the juicing screw and the
strainer to vibrate.
2.- If the ingredient contains strong fi ber, the
vibration from the top-set may be stronger.
55