Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
POSSIBLE CAUSE
Not plugged in.
The light
The circuit breaker tripped or
does not
a blown fuse.
work.
The light button is "OFF".
The cooler is not leveled.
Vibrations.
The bottles are vibrating
There is an object under the
cooler.
The cooler is not level.
The cooler
seems to
make too
much noise.
Normal noise from the flow
of the refrigerant
The cooler is not level.
The door
The door was reversed and
will not
not properly installed.
close
properly.
The gasket is dirty.
The shelves are out of
position.
14
SOLUTION
Plug the cooler in.
Check the breaker and/or fuses.
Press
to turn the light ON.
Check to assure that the cooler is level.
Make sure the bottles don't touch each
others.
Remove the object under the cooler.
Level the cooler.
The rattling noise may come from the flow
of the refrigerant, which is normal. As
each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant
in your cooler. Contraction and expansion
of the inside walls may cause popping
and crackling noises.
Level the cooler.
Re-install the door properly.
Clean the door gasket.
Place the shelves properly.
This is normal during high
humidity periods.
This is normal in high
Moisture
temperature environment.
builds up on
interior or
exterior of
the wine
Prolonged or frequent door
openings.
cooler.
The door does not seal
completely.
Error Code:
E1-E2-E3-E
A sensor has failed.
4-E7-E8
Lower the room humidity.
Move the cooler to a cooler place, and
avoid heat and sunlight.
Less to open the door.
Check door gaskets for proper seal.
Contact the qualified technician.
15
Publicité
