Publicité
Les langues disponibles
Les langues disponibles
Illustration #1
To Install Your Wine Cooler
• This wine cooler is designed for free standing or built-in (fully recessed) installation.
• Place your wine cooler on a solid and level floor that is strong enough to support it
when it is fully loaded. This will ensure a vibration-free and noise-free operation. Adjust
the leveling legs in and out to stabilize the cooler horizontally. If the legs are not properly
adjusted, the cooler may be unstable and result in excess noise or vibration.
• Locate the wine cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extremely cold ambient temperatures may also cause
the cooler not to perform properly.
• It is not advisable to install this cooler in moist areas or directly adjacent to a kitchen
sink, as moisture could cause premature corrosion to the components of your new
cooler.
• It is recommended you install the wine cooler in a place with temperatures above 60°F
(15°C) and below 90°F (32°C), and humidity is under 60%. If the ambient temperature is
above or below recommended temperatures, the performance of the cooler may be
affected. Placing your cooler in extremely cold or hot conditions may cause interior
temperatures to fluctuate, and the temperature range of 5ºC-18ºC (40ºF-65ºF) may not
be reached.
• Connect the wine cooler to an exclusive, properly grounded, standard electrical supply
(115 V AC only, 60 Hz), in accordance with the National Electrical Code and local codes
and ordinances. Any questions concerning power and/or grounding should be directed
toward a certified electrician.
Warning: Improper use of the grounded plug can result in the risk of electrical
shock. If the power cord is damaged, have it replaced by qualified technician.
08
Illustration #2
1 Gasket
2 Screw
3 Screw Driver
4 Handle
• The wine cooler should always be plugged into its own individual electrical outlet which
has a voltage rating that matches the rating label on the wine cooler. This provides the
best performance and also prevents overloading house wiring circuits that could cause a
fire hazard from overheated.
• Do not under any circumstances cut or remove the third ground prong from the power
cord supplied.
• Do not use an extension cord or adapter plug. However, if you must use an extension
cord, it is absolutely necessary that it be a UL-listed, 3-wire grounding type wine cooler
extension cord having a grounding type plug and outlet and that the electrical rating of
the cord is 10 amperes (minimum) and 120 volts.
• Do not use a cord that shows cracks or abrasion damage along its length or at either
end.
• If the wine cooler is going to be used in an area that is prone to power surges/outages,
it is suggested that you use a power surge protector. The surge protector that you select
must have a surge block high enough to protect the wine cooler it is connected to.
OPERATION INSTRUCTIONS
Controls
After plugging the wine cooler into a wall outlet, the cooler would turn on automatically
and the LCD screen would show the temperature inside of the cooler. After setting your
desired serving temperature, allow the cooler to cool down for 3 to 4 hours before
placing wine bottles in the wine cooler.
Press
once to turn the interior light ON or OFF.
Press
to increase or press
between Upper zone：5-13℃(40-55℉) Lower zone：13-18℃(55-65℉).
Press to begin adjusting the temperature for upper or lower zone.
Press once to turn ON the cooler. Press and hold
to turn OFF the cooler.
Toggles the temperature display between Celsius and Fahrenheit.
to decrease the temperature in 1 degree increments
about 3 seconds
09
Publicité
