ADURO 14 Mode D'emploi page 31

2.4 Mounting of safety wire on Aduro 15 & 15.2
The stove comes with a safety wire. Please follow the mounting instructions below:
1. Mount the bracket on the wall central to the stove: approx. 53 cm above the floor hearth.
2. Slide the safety wire through the two oblong holes in the backplate of the stove as well as through
the eye in the wall bracket. The safety wire ends must be secured in the rectangular wire lock.
3. The length of the wire is adjusted and the wire lock tightened. Excess wire is cut off. In case the wire
should be real tightened, the stove can temporarily be pushed slightly against the wall, while
tightening the wire.
2.5 Attachment / hanging of Aduro 15.3
Aduro 15.3 must be installed on a non-flammable wall. The stove is being delivered with wall fittings which
must be properly fastened to the wall before mounting the stove (instructions are enclosed with the stove).
You may consult your normal supplier of building materials about suitable attachment materials for the
stove/wall before the mounting. ONLY USE FIXING MATERIALS WHICH CANNOT MELT. If you have any
doubts about the requirements, please consult your chimney sweep who will inspect the stove.
The lower edge of the stove must be minimum 24 cm above the floor.
31