Haier HB16FMAA Manuel D'utilisation page 29

GB
10.5 Aligning the appliance
The appliance should be placed on a flat and solid sur-
face.
1. Tilt the appliance slightly backwards (Fig. 10.5).
2. Set the feet to the desired level.
3. The stability can be checked by alternately bump-
ing on the diagonals. The slightly swaying should
be the same in both directions. Otherwise the
frame can warp; possible leaking door seals are
the result. A low tendency to the rear facilitates
the closing of the door.
10.6 Fine tuning of the doors
If the doors are not in one level, this mismatch can be
remedied by following:
10.6.1 Using adjustable foot
Rotate the adjustable foot according to the direction of
arrow i(Fig. 10.6-1) to turn up or down the foot.
10.6.2 Using spacers
▶ Open the upper door and lift it.
▶ Carefully clip the spacer (enclosed in the accessory
bag) in the white plastic ring of the middle hinge by
hand or using tools like pliers (Fig. 10.6-2). Do not
scratch or bruise the door.
Notice: Levelling
In the future use of refrigerator, doors uneven phenomenon may occur to the weight of
stored food. Then please adjust according to the above methods.
10- Installation
1.
max 45°
3.
10.5
2.
10.6-1
10.6-2
29