Hunter The Care Free Ultra 38257 Mode D'emploi page 11

Problem:
Excessive noise.
Solution:
1. Check the Water Tank to make sure
it is properly seated on the Power Pack.
2. Check the Water Tank to make sure
there are no bubbles when the Water
Tank is full and running. If there are bub-
bles, turn the unit OFF until the bubbling
stops. When the bubbling has stopped,
set the unit to the desired speed.
3. Remove and clean the Pump Cap
and Funnel Pump. Refer to the section
on CLEANING THE HUMIDIFIER AND
THE WATER TANK.
Problem:
Humidifi er not working.
Solution:
1. Make sure the Power Knob is not set
to OFF.
2. Adjust the humidity level using the
Power Knob and the Humidistat Controls.
Once the room reaches the set humidity
level, the humidifi er will turn OFF; this is
normal.
3. Make sure the Power Pack and Water
Tank are both fully seated in the three
tabs on the Upper Reservoir.
4. Make sure the Atomizer is facing the
proper direction.
Problem:
Humidifi er will not turn on.
Solution:
1. Check the three posts on the top
surface of the Atomizer are properly en-
gaged. The side of the Atomizer with three
short posts should be facing upward.
42992-01 05/23/2006
42992-01/-05.indd 11
All manuals and user guides at all-guides.com
Troubleshooting
Problem:
Solution:
Problem:
Solution:
11
2. Make sure the Water Tank is properly
seated on the Power Pack.
3. Check the humidity levels on the display.
If the ambient room humidity is equal to
or higher than the set level, the unit will
not turn on.
Mineral build-up on the Water Tank or Upper
Reservoir.
1. Refer to the section on CLEANING
THE HUMIDIFIER AND THE WATER
TANK.
Humidity output and water usage
decreased.
1. Make sure the Atomizer is positioned
correctly, with the side with three posts
facing upward.
2. Check the Humidistat Setting and
Power Knob to make sure they are set
to the desired humidity level.
3. Check the Water Tank to make sure
there are no bubbles when the Water
Tank is full and running. If there are bub-
bles, turn the unit OFF until the bubbling
stops. When the bubbling has stopped,
set the unit to the desired speed.
4. Clean any components that have
mineral build-up. Refer to the section
on CLEANING THE HUMIDIFIER AND
THE WATER TANK.
continued
©2006 HUNTER FAN CO.
5/23/06, 12:30:16 PM