Chapin 61813 Manuel D'utilisation Et D'entretien page 4

SPRAYER COMPONENTS & USE INFORMATION, Continued
WAND ASSEMBLY
1. Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.
Retaining Nut
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft
(A). To install the pump handle place the handle (C) over the shaft (A)
aligning the pump handle holes and shaft holes. Slide the bolts (B)
through the aligned holes as shown in figure 3. Tighten nuts (D) to bolts.
There are holes in the pump handle to allow for either left (fig.2-4) or
right (fig.5) hand mounting.
Nylon Lock Nut
Threaded Bolt
Figure 1
Figure 4
Tighten nut to bolt
INSTALLING THE SHOULDER STRAP
The backpack strap is provided with
multiple features including shoulder
strap, chest strap, waist belt and lumbar
support. (figure 1). The top the shoulder
strap is attached to the top of the tank
and is removable. The hook from the
lumbar support attaches to the base tube
on the bottom of the tank (figure 2).
O-ring
Wand
Pump
Handle
Figure 2
Line up holes
Figure 5
Right Hand
Figure 1
Strap Assembly
3E
Shut-off
Valve
A. Pump Shaft
Pump
Shaft
Figure 3
Slide bolts through holes
Completed Assembly
Shoulder
Strap
Chest
Strap
Lumbar
Support
Waist
Belt
D. Nuts
B. Bolts
C. Pump Handle
Hook
Figure 2
Hook Attachment
Lumbar
Support
Base
Tube