Black & Decker FSM1605 Mode D'emploi page 6

ENGLISH (Original instructions)
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
with the handle (4) supported in the upright position when
stationary and make sure the steam mop is turned off when
not in use.
After use (Fig. E)
Turn the steam mop 'OFF'. turn the steam operation
u
button (2) to off and then press the ON/OFF button (1).
Wait until the steam mop cools down.
u
Unplug the steam mop from the electrical wall outlet.
u
Empty the water tank.
u
Remove the cleaning pad (6) and wash it ready for next
u
use.
Clip the supply cable around the cable tidy hooks (7
u
and 8)
There is a hanging bracket (10) built into the hand grip (9)
u
which allows your steam mop to be hung from a suitable
hook on the wall. Always ensure that your wall hook is
capable of supporting the weight of the steam mop safely.
Technical Data
FSM1605(R)
(Type 1)
Voltage V 230
ac
Power W 1300
Tank
ml 350
Capacity
Weight kg 2.7
6
All manuals and user guides at all-guides.com
Troubleshooting
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Problem
The steam mop is not
turning on
The steam mop is not
producing steam
The steam mop stops
producing steam
FSM1615
during use
(Type 1)
The steam mop stops
producing too little
230
steam during use
1300
The steam mop is
producing too little
steam during use
350
Where can I get
further information/
3.1 accessories for my
steam mop
Step Possible solution
1. Check the unit is
plugged in at the wall
socket.
2. Check the unit is
switched on using the
ON/OFF switch (1)
3. Check the fuse in the
plug.
4. Check the water tank
(3) is full and correctly
fitted.
NOTE: When first filled
or after running dry it
can take up to 45
seconds for steam to
be produced.
5. Check the steam
generation button is in
the ON position.
6. Check step 1, then 2,
then 3.
7. Check step 4, then 2,
then 3
8. Check step 4
9. Refer to the assembly
chapter of the manual
for correct fitting of
parts and
accessories.