Black & Decker FSM1605 Mode D'emploi page 5

Caution: Always place your steam mop with the handle (4)
supported in the upright position when stationary and make
sure the steam mop is turned off when not in use.
Removing a cleaning pad
Caution! Always wear suitable shoes when changing the
cleaning pad on your steam mop. Do not wear slippers or
open toed footwear.
Return the handle (4) to the upright position and turn the
u
steam mop 'OFF'.
Wait until the steam mop cools down (approximately 5
u
minutes).
Lift the steam mop away from the cleaning pad freeing it
u
from the velcro fastening.
Caution! Always place your steam mop with the handle (4)
supported in the upright position when stationary and make
sure the steam mop is turned off when not in use.
Filling the water tank (Fig. D)
The water tank on your steam mop is removable for
convenient and easy filling.
Note! Fill the water tank with clean tap water.
Note! In areas of hard water, the use of de-ionised water is
recommended.
Remove the water tank (3).
u
Remove the filter cap by unscrewing in an anti-clockwise
u
direction.
Fill the water tank (3) with water.
u
Warning! Your water tank has a 350ml capacity. Do not over
fill the tank.
Replace the filter cap by screwing in a clockwise direction.
u
Re-fit the water tank (3).
u
Note! Ensure the filter cap is firmly secured.
Note! Do not use chemical cleaners with your steam mop
water tank.
Use
Important! This unit will kill 99.9% of bacteria and germs
when used in accordance with the instructions in this manual
and with the micro fibre pad fitted and a continuous run time
of 90 seconds.
Switching on and off
To switch the appliance on, press the ON/Off button (1).
u
It takes approximately 15 seconds for the steam mop to
heat up.
Press the steam operation button (2). This will operate the
u
pump and the unit will begin to produce steam.
To stop steam generation, turn the steam operation button
u
(2) to off. This will maintain power to the boiler for quicker
start up.
All manuals and user guides at all-guides.com
u
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
with the handle (4) supported in the upright position when
stationary and make sure the steam mop is turned off when
not in use.
Caution! Always empty the steam mop after use.
Note! When first filled or after running dry, it can take up to 45
seconds for steam to be produced.
Hints for optimum use
General
Caution: Never use the steam mop without first attaching a
cleaning pad.
u
u
u
Steam Cleaning
u
u
u
u
u
Note! When first filled or after running dry, it can take up to 45
seconds for steam to be produced.
u
u
u
Caution! It is important to monitor the water level in the water
tank (3). To refill the water tank and continue to sanitize/
clean stand the mop upright making sure that the handle is
supported and turn the steam mop 'OFF'. Unplug the unit from
the electrical wall outlet, remove and refill the water tank (3).
(Original instructions)
To switch the appliance off, press the ON/Off button (1).
Always vacuum or sweep the floor before using the steam
mop.
The easiest way to use the appliance is to tilt the handle
to a 45º angle and clean slowly, covering a small area at a
time.
Do not use chemical cleaners with your steam mop. To
remove stubborn stains from vinyl or linoleum floors, you
can pre-treat with a mild detergent and some water before
using the steam mop.
Place a cleaning pad (6) on the floor with the velcro 'loop'
side facing up.
Lightly press the steam mop down onto the cleaning pad
(6).
Connect the steam mop to the mains.
Press the ON/OFF button (1). It takes approximately 15
seconds for the steam mop to heat up.
Press the steam operate button (2). After a few seconds,
steam will start to come out of the steam head.
It takes a few seconds for steam to enter the cleaning pad.
The steam mop will now glide easily over the surface to be
sanitized/cleaned.
Push and pull the steam mop slowly across the surface to
thoroughly steam clean each section.
When you have finished using the steam mop, return
the handle (4) to the upright position, making sure that it
is supported and turn it 'OFF'. Wait until the steam mop
cools down (approximately five minutes).
ENGLISH
5