Télécharger Imprimer la page

SFA Pro-Lift B-033D Manuel Des Consignes D'utilisation Et Des Pièces page 4

Crics-bouteilles hydrauliques, capacité 27 215 kg (30 tonnes américaines)

Publicité

Les langues disponibles

Les langues disponibles

Lowering
!
WARNING: Clear all tools and personnel before lowering load. Open release valve slowly. The further handle is
turned counter-clockwise, the faster the load will descend. Maintain control of the load at all times.
1. Raise load high enough to clear the jack stands, then carefully remove jack stands.
2. Slowly turn the Pump Handle counter-clockwise, but no more than 1/2 turn. If the load fails to lower:
a. Use another jack to raise the vehicle high enough to reinstall jack stands.
b. Remove the affected jack and then the stands.
c. Use the functioning jack to lower the vehicle.
3. After removing jack from under the load, push Ram Plunger and Handle Sleeve down to reduce exposure to rust
and contamination.
MAINTENANCE
NOTICE:
potential for sudden and immediate loss of load. Premium hydraulic jack oil is recommended.
Adding oil
1. With Ram Plunger fully lowered and pump piston fully depressed, set jack in its upright, level position. Remove
Oil Filler Plug/Screw.
2.
Changing oil
1. With Ram Plunger fully lowered and pump piston fully depressed, remove the Oil Filler Plug/Screw.
NOTICE: Dispose of hydraulic oil in accordance with local environmental regulations.
3.
4. Perform Bleeding/Venting Trapped Air procedure (page 2). Reinstall the Oil Filler Plug/Screw.
Lubrication
A periodic coating of light lubricating oil to pivot points, axles and hinges will help to prevent rust and assure that
pump assemblies move freely.
Cleaning
Periodically check the pump piston and Ram Plunger for signs of rust or corrosion. Clean as needed and wipe with
an oily cloth.
NOTICE: Do not use sandpaper or abrasive material on ram or pump piston surfaces.
Storage
When not in use, store the jack with pump piston and Ram Plunger fully retracted and air supply disconnected.
.
4
.
.

Publicité

loading