Télécharger Imprimer la page

Dometic BS 115WP Instructions De Montage Et De Service page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36
 
NOTICE! Damage hazard
• Ensure that other objects cannot cause a short circuit at the contacts of the device.
• Ensure that the negative and positive poles never come into contact.
• Do not step or lean on the solar panels.
• Do not put excessive load on the glass or back sheet of the solar panels as this may break the cells or
cause micro cracks.
• Store the solar panel in a safe place before mounting or after dismounting. Protect the solar panels
from falling over or down.
Installing the device safely
DANGER! Explosion hazard
Failure to obey these warnings will result in death or serious injury.
Never mount the device in areas where there is a risk of gas or dust explosion.
WARNING! Risk of injury
Failure to obey these warnings could result in death or serious injury.
If you install the solar panel on a roof:
• Do not carry out installation and mounting in strong winds.
• Protect yourself and other persons from falling down.
• Prevent the possible falling of objects.
• Secure the work area so that no other person can be injured.
NOTICE! Damage hazard
Improperly mounted solar panels can get loose and fall down. Do not use silicone or any adhesive other
than the recommended one to ensure optimum adhesion.
Safety when connecting the device electrically
WARNING! Electrocution hazard
Failure to obey these warnings could result in death or serious injury.
• The electrical installation may only be connected by qualified personnel and only in accordance
with the national regulations. Incorrect connection may cause severe hazards.
• If you are working on electrical systems, ensure that there is somebody close at hand who can help
you in emergencies.
• Observe the recommended cable cross-sections.
• Lay the cables so that they cannot be damaged by the doors or the hood. Crushed cables can lead
to serious injury.
NOTICE! Damage hazard
• Do not exceed the current and voltage ratings of the solar charge controller. Only install solar pan-
els up to the maximum power rating of the used solar charge controller. If your solar system exceeds
these ratings, contact your dealer for a suitable solar charge controller.
• Use ductwork or cable ducts if it is necessary to lay cables through metal panels or other panels with
sharp edges.
• Do not lay the 230 V mains cable and the 12 V cable in the same duct.
• Do not lay the cable so that it is loose or heavily kinked.
EN
9

Publicité

loading