GE 21028 Mode D'emploi page 30

2. Dial the desired number
or
Press the CID/VOL (
or
Press MEM button and then use CID/VOL (
desired memory record.
3. Press SPKR to dial number
4. When finished, press the SPKR button again to hang up.
NOTE: If you are using the handset earpiece and want to switch to the
speakerphone, press the SPKR button, you can then press SPKR again to end
conversation. If you are using the speakerphone and want to switch to the
handset earpiece, press the TALK/END/CALLBACK button, you can then
press TALK/END/CALLBACK again to end conversation.
C T
ALL IMER
After you press the TALK/END/CALLBACK button on the handset, the built-in
call timer shows on the display and counts the length of time of the call in
minutes and seconds.
P -D
RE IALING
1. Make sure the phone is OFF (not in talk mode).
2. Enter the telephone number you want to call. The telephone number
shows in the handset display.
3. Press the TALK/END/CALLBACK or SPKR buttons on the handset, and
the number automatically dials.
NOTE: You may enter up to 32 pre-dial digits.
NOTE: If you want to delete the pre-dial number you entered, press the DEL
button until all of the digits are erased, or press the *exit button to erase all
numbers at once.
A S
UTO TANDBY
If you place the handset in the cradle while the handset is off the hook
(during a call), the call is automatically disconnected.
R HI/LOW/OFF S
INGER
Apart from the setting in the main menu, there is a shortcut to set the
ringer. Make sure the phone is OFF (not in talk mode).
30
All manuals and user guides at all-guides.com
or ) button to select the desired record,
HORTCUT
or ) button to scroll to