GE 21028 Mode D'emploi page 11

I
NSTALLING THE
NOTE: You must connect the handset battery before use.
1. Connect battery pack plug to jack inside compartment on base.
NOTE: It is important to maintain the polarity (black and red wires) to the
jack inside the compartment as shown in the illustration. To ensure proper
battery installation, the connector is keyed and can be inserted only one way.
2. Install compartment cover and snap into place.
3. Place the handsets in the charging cradles.
Allow handsets to charge for 16 hours prior to first use. If you don't
properly charge the handsets, battery performance is compromised.
NOTE: If the battery is not properly installed in the handset, or if the battery
pack is not properly connected to the jack inside the battery compartment.
"NO BATTERY" shows in the display when the handset is placed in the
charging cradle.
I
NSTALLING THE
Choose the best location to install your base and handset charge cradle.
Your base and handset charge cradle should be placed on a level surface
such as a desk or table top.
All manuals and user guides at all-guides.com
H B
ANDSET ATTERY
PRESS DOWN
FIRMLY
P
HONE
BATTERY
BLACK WIRE
RED WIRE
11