Publicité
Les langues disponibles
Les langues disponibles
I.
1.
II.
1.
2.
3.
Operating instructions
I. Description
1
Luminaire
2 Wall mount
3 Fixing screw
4 Power cable
5 Connection terminal
2.
6 Screw cap
3.
4.
5.
6.
II. Assembly
1. Select an installation location without pipes or cables behind it. Mark the fastening holes, and
drill the holes for the clamps. Ensure that these are positioned according to the fixing slots in
the wall mount.
2. Insert the plugs, and fix the luminaire with the screws.
Caution: Make sure the fasteners are suitable for the wall material.
3. Adjust the luminaire 1 in the desired angle. If necessary, loosen the angle fixing screws 3 and
tighten them again.
4. Connect the luminaire 1 to the power supply (see section III).
36
III. Connection
Caution:
First disconnect the power supply for this connection.
Disassemble the connection terminal 5. Remove 8 mm of insulation from each cable. Push cable
1
through the cable inlet and connect the luminaire 1 to the power supply (see figure).
2 Fix the cables by tightening the screws. Make sure that the connections are tight and that no
loose cable endings emerge from the terminal.
N:
Blue
L:
Brown
:
Yellow/Green
3 Reassemble the connection terminal 5 and tighten the screw cap 6 with 10 Nm. Make sure the
cable insulation reaches well within the connection terminal 5.
Connect the power supply.
IV. Maintenance and care
Cleaning
Wipe the luminaire with a soft, damp cloth only. Never use scouring powders or chemical cleaning
agents. Never allow the electrical components to become damp.
GB
IIl.
1.
2.
15 mm
8 mm
IV.
37
3.
Publicité
