Starway Enzo Manuel De L'utilisateur page 48

ENZO FIRMWARE UPDATE
1. Place the update files in a Enzo named directory on a USB key
2. Turn on the projector DMX and ARTnet disconnected, insert the USB key into the connector located on the front panel.
3. Go to the menu by pressing "Mode" è "Function" è "USB Update" è "On".
4. The screen displays the available directories è select «Enzo»
5. Select «ON» è press «Enter» to validate.
6. The update process starts and will upgrade each electronic board.
The projector will perform a reset at the end of the process
7. Remove the key and check the software versions by pressing «Mode» > «Information» > «Software. V» > «Enter»
MENU TEST
Page 48