Télécharger Imprimer la page

Starway Enzo Manuel De L'utilisateur page 47

Publicité

Les langues disponibles

Les langues disponibles

Fixture ID
Sub-menu allowing the modification of the receiving DMX universe (ArtNet and sACN) as well as Enzo's IP address and the
subnet mask. To enter is this sub-menu the PIN code is "050"
Universe: 0-255 - Selection of the DMX receiving universe
UnitIPAddr: xxx.xxx.xxx.xxx - Selection of the Enzo IP address
MaskAddr: xxx.xxx.xxx.xxx - Selection of the Enzo subnet mask
Net Switch
Sub-menu allowing the activation or deactivation of Enzo's Ethernet switch
Dim Speed
Sub-menu allowing the dimmer's smoothing choice between Standard (default), Stage, TV, Architectural or Theater..
Temp C°/F°
Sub-menu for selecting the Celsius (default) or Fahrenheit system, for displaying the temperature.
Dim Curve
Submenu allowing the selection of the dimmer curve between Linear (default), Square, Exp, Log and S-Curve.
Frequency
Sub-menu allowing the selection of the refresh rate of the LED to avoid a possible «flicking» during video filming. Change-
able value between 900Hz (default) and 25Khz.
Gobo CTC filter
A color temperature corrector filter is automatically provided to compensate for the color temperature drop down of the
glass gobos.
In this sub-menu you can activate (by default) or not this function
Fan Set
- Head Fan
Sub-menu for selecting the head fan behavior between Auto (default) and Low or High.
- Base Fan
Sub-menu for selecting the base fan behavior between 90% (default), 75% or 50%.
LCD Set
Sub-menu allowing to select the behavior of Enzo's display.
Backlight - 02m to 60m - Selection of the display backlight retention time (without menu manipulation) from 2
minutes to 60 minutes. Time set to 5 minutes by default.
Flip Display - ON / OFF - Reversal of the display direction
KeyLock - ON / OFF - Locking of the Enzo's buttons.
DispFlash - ON / OFF - Activation or not of the display flash when the Enzo does not receive a DMX signal.
.
Disp.Set
Chan.Value - continuous display of DMX values of all channels.
Slave Set - Selection of Enzo slave mode to "offset" Enzo when using Master / Slave mode - between Slave 1,
Slave2 and Slave 3.
Auto Prog - Master / Slave mode selection:
In MASTER mode, master Enzo transmits the information to all Enzo
connected using a DMX cable and where Slave mode has been activated
in the "Slave Set" submenu
In ALONE mode Enzo does not transmit information and executes
its AUTO mode individually.
DFSE
- ON/OFF - Reloading the Enzo default settings.
USB Update
- ON/OFF - Enzo firmware update.
Page 47

Publicité

loading