Kenwood CM900 Serie Mode D'emploi page 6

NOTE: The lid must be fitted
to the carafe in order to
operate the anti-drip valve.
5 Plug in and switch on – the neon
light will come on.
6 Don't remove the carafe until
brewing has finished.
G The separate element for the
hotplate ensure that the coffee is
maintained at the correct
temperature after brewing.
G The hotplate will keep your coffee
hot, but the sooner you drink it, the
better it will taste.
G Your coffee maker will keep the
coffee warm and then automatically
switch off after 2 hours.
G If you haven't used the machine for
a while, run one lot of water through
it (without coffee) to clean it out. Fill
the water tank to the top cup mark
when you do this.
care & cleaning
G
Always switch off, unplug and allow
to cool before cleaning.
G
Never put the machine in water or let
the cord or plug get wet.
G
Don't wash parts in the dishwasher.
G
Wipe with a damp cloth, then dry.
Don't use abrasives - they'll scratch
the plastic and metal surfaces.
removable parts
G
Wash in hot soapy water, then dry.
descaling
After 90 brewing cycles the de-scale
warning light will come on and flash
to indicate that the coffee maker
requires descaling (see 'to descale')
Get other manuals https://www.bkmanuals.com
to descale
1 Buy a suitable descaler.
2 Descale the machine following the
descaler manufacturer's instructions.
3 After descaling, run several lots of
water through the machine to clean
it out. Fill the tank to the top cup
mark when you do this.
4 Wash the parts.
5 Plug in and switch on.
6 Reset the de-scale warning light by
pressing the button at the back of
the coffee maker
service
G
If the cord is damaged it must, for
safety reasons, be replaced by
Kenwood or an authorised Kenwood
repairer.
If you need help with:
G
using your machine or
G
servicing or repairs
Contact the shop where you bought
your machine.
3
.