BM 1619X04880 02-12_BM 1619X04880 02-12 2/20/12 11:05 AM Page 8
BLADE INSTALLATION AND REMOVAL
CAUTION
there is no blade in the blade clamp or when
inserting the blade.
Insert the saw blade (teeth in cutting direction)
into the slot in the blade clamp until the blade
ejector lever rotates to the LEFT, indicating that
the clamp has engaged. (When inserting the
saw blade, the back of the blade must rest in
the groove of the guide roller Fig. 2.)
The tool should be held so that the blade is
safely ejected. To remove the saw blade, rotate
the blade ejector lever to the center stop to the
RIGHT; this releases and ejects the saw blade
(Fig. 3).
BLADE CLAMP RESET – There are two
situations in which it is necessary to reset
the blade clamp:
RESET Type A: If the blade ejection lever is
rotated improperly, the "fingers" within the
clamp may slip into the blade insert slot. To
reset the clamp:
Step 1 – Using a a screwdriver, push down on
blade clamp fingers (as viewed from the bottom
of the jig saw), until clamp can be rotated.
Step 2 – Rotate blade ejector lever to the
RIGHT until it locks into place.
The clamp is now ready for use.
RESET Type B: If the two fingers inside the
blade clamp accidentally get pushed too far
into the plunger, they will prevent insertion of a
blade. To bring the fingers back to their
correction positions:
Step 1 – Turn the blade ejector lever to the
RIGHT (as viewed from the bottom of the jig
saw)
Step 2 – Continue the rotation unto fingers will
snap into the correct open position.
VARIABLE SPEED CONTROLLED
Your tool is equipped with a variable speed trigger
switch. The tool can be turned "ON" or "OFF" by
squeezing or releasing the trigger. The speed can
00.544.2843
To prevent damage, do not
turn blade ejector lever when
BLADE INSTALLATION
BLADE EJECTION
Operating Instructions
TRIGGER SWITCH
www.calcert.com
15
10
20
5
25
0
30
Assembly
The clamp is now ready for use.
BLADE
BLADE CLAMP IN OPEN POSITION
(As viewed from the bottom)
BLADE
BLADE CLAMP IN LOCKED POSITION
(As viewed from the bottom)
be adjusted from the minimum to maximum RPM
as set on the variable speed dial by the pressure
you apply to the trigger. Apply more pressure to
increase the speed and release pressure to
decrease speed (Fig. 1).
-8-
FIG. 2
BLADE
CLAMP
LEVER
FINGERS
FIG. 3
BLADE
CLAMP
LEVER
FINGERS
sales@calcert.c