Black & Decker Dustbuster V2400 Mode D'emploi page 7

All manuals and user guides at all-guides.com
BEFORE FIRST USE
Before first use, the battery must
be charged for at least 16 hours.
Before charging, preferably
discharge the battery by
operating the appliance until
the motor stops.
Charge the battery as
described below.
USE
Operating the appliance (fig. C)
To switch on, slide the on/off
switch (1) forward.
To switch off, slide the on/off
switch back.
Charging the battery (fig. D)
Make sure that the appliance
is switched off. The battery
will not be charged with the
on/off switch in the on
position.
Place the appliance on the
charging base as shown.
Plug in the charger. Switch on
at the mains.
Leave the appliance to
charge for at least 16 hours.
Whilst charging, the charger may
become warm. This is normal and
does not indicate a problem.
The appliance can be left
connected to the charger
indefinitely. When the battery is
fully charged, the power
consumption of the charger is
negligible.
Important! Place the appliance
on the charging base whenever it
is not in use. After fully charging
the battery, the average effective
usage time is approx. 7 to 9
minutes. It may take several
charging cycles before the
battery attains full capacity.
Do not charge the battery at
ambient temperatures
below 4 °C or above 40 °C.
Dustbuster_EUR_A5_A6.PM5
E N G L I S H
Accessories - V2410/V2410G/
V3610/V3610P (fig. E & F)
These models are supplied with
the following accessories (fig. E):
- a crevice tool (10) for
confined spaces
- a hard brush (11) for furniture
and stairs
To fit an accessory, proceed as
follows (fig. F):
Take the accessories from the
appliance.
Insert the appropriate
accessory into the front of the
appliance.
You may refit the other accessory
by clicking it into the accessory
holder.
To refit both accessories:
Insert the brush into
accessory holder.
Slide the crevice tool into the
brush.
Push the accessories down
until they click into place.
TROUBLESHOOTING
If the product does not work,
follow the instructions below.
If this does not solve the problem,
please contact your local
Black & Decker repair agent.
Make sure the battery is fully
charged.
If the battery cannot be
charged, check if the charger
is plugged in correctly and
the mains is working.
Make sure the on/off switch is
in the off position.
CLEANING AND
MAINTENANCE
Regularly clean the filters.
7 01-05-2001, 11:30
7