Installation And Use - Thetford Tecma sanisplit 600 Installation Et Mode D'emploi

5. Detach the removable unit and remove any obstruction from the macerating chamber as
shown as shown in Fig. 12.
6. Once the maintenance is completed, reattach the removable part by tightening the knob
up unit it is firmly connected to the tank collection unit.
In case of operation failure (partial obstructions, misuse, etc.) press the manual start
button located on the side of the device (Fig. 8) until the problem is resolved.
Keep pressed for no longer than 20 seconds to a max of 3 cycles.

2.3. Installation and use

Sanisplit consists of a box that incorporates a pump that can automatically chop and expel
acid, fatty hot water (up to 70°C) faeces and toilet paper through a 32 or 40 mm diameter
pipe to the nearest sewer.
It may be used to collect and pump under pressure (refer to the performance- related graph)
the discharges of the sanitary fittings located in both the bathroom (EN-12050-3 EN-12050-
4) or the kitchen, including washing machine, dishwasher, and any other device that needs to
discharge waste water.
In accordance with EN-12050-3 and EN-12050-4, if the macerator collects waste water (toilet),
only one washbasin and/or one bidet and/or one shower may also be connected.
In cases where it is not possible to interrupt the inflow into the product during normal
operation, the installation shall be equipped with a stand-by pumping device of the same
capacity, which starts automatically where necessary.
The installation shall be made in compliance with the prescription of the European Standard
EN 12056-4.
Fix the water tank unit with two crew plugs (Ø 3,5 mm) or similar, using the fixing holes.
Sanisplit (Type: Sanisplit 1, 2, 3 Combi) can be connected to any type of toilet having a wall
discharge in compliance with European standards.
It is connected by inserting the toilet discharge into the rubber coupling on the tank and fixing
it with the clamp supplied (Fig. 1).
The outlet and other units of bathroom or kitchen equipment are connected to the back of
the appliance (Fig. 2), so all those pipes, connectors, valves etc. that inevitable spoil the
appearance can disappear. However it's possible to connect pipes externally (Fig. 3, Fig. 4 and
Fig. 5). Bathroom or kitchen items must be connected as shown in Fig. 2. For dishwashers and
washing machines only, can be utilized either of the two inlet connections.
It is recommended the use of 1 Sanisplit for bathroom or kitchen. In any case do not connect
to Sanisplit more than 1 appliance operating potentially continuously (es. no more than 1
shower)
N.B.: The shower plate and bathtub must be at least 20 cm above floor level (Fig. 6).
All sanitary equipment connected must allow the interruption of water flow.
Sanisplit has tank ventilation as shown on Fig. 6.
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Rev.04
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordresidential.com
9