Bosch MW1-RX Instructions D'installation Et D'utilisation page 16

UHF Wireless Microphone System | Installation and User Instructions |
5.2 Handheld microphone
1 Turn the handheld microphone ON by switching the
ON/OFF switch on the rear of the microphone to
the ON position.
2 Slide the cover down by pushing the rimmed knob
on the side.
Frequency selection
1 Press the wheel for 3 seconds to activate the menu.
2 Once you see "MHZ" blinking, you can select the
required frequency by rotating the wheel UP and
DOWN.
3 Press the wheel to store the selected frequency.
Note
In case the handheld microphone is locked,
the settings can not be changed. For unlock,
see instructions on Lock mode.
Sensitivity adjusting
1 Press the wheel for three seconds to activate the
menu.
2 Press the wheel 1 time and Sensitivity (SEnSit)
appears on the display.
3 Rotate the wheel UP and DOWN to adjust the
setting.
4 Press the wheel to store the setting.
Sensitivity range: 0, -10, -20, -30 dB.
Default setting of sensitivity is -20 dB.
Lock mode
1 Hold the wheel for 3 seconds to activate the menu
2 Press 2 times to select the "Lock mode".
3 Push the wheel UP or DOWN to change the setting.
4 Press the wheel to store the setting
Note
In case the LOCK mode is ON, the handheld
microphone cannot be switched OFF.
Bosch Security Systems | 2006-01 | 9922 141 50701ml
All manuals and user guides at all-guides.com
5.3
Frequency adjusting
1 Turn the belt-pack ON by setting the switch to the
2 Slide down the slider around the belt-pack
3 Push the SET button for 3 seconds to activate the
4 Once "MHZ" is blinking, the required frequency can
5 Press the SET button again to store the selected
figure 5.3: Adjusting the frequency
Belt-pack transmitter
ON position.
transmitter.
Menu.
be selected by using the UP and DOWN buttons.
frequency.
Note
In case the belt-pack is locked, the settings can
not be changed. For unlock, see instructions on
Lock mode
UP
Down
en | 16
"MHZ"
SET