Astralpool Flexi RGB Wireless Manuel D'installation Et D'entretien page 4

COLOUR Nº COLOUR
1
2
3
4
5
6 Magenta
- Selecting sequences
The SEQUENCE button enables you to select one of the 8 available sequences. Each time the button is pressed, the
sequence changes; when the last sequence is reached, pressing again goes back to the first sequence. All sequences
work in cycles; when the last sequence is reached the cycle starts again.
The numbers of the sequences appear on the display numbered from 1 to 8.
SEQUENCE
Estival
Red Green
Caroline
Cyan Magenta
Iris
Green Esmerald green
Candy
Red Orange
Tropical Red
Paradise Red Orange
Abril
Pale violet Magenta
Eleven
Red Green
- Refresh button
In pools with more than one LumiPlus Flexi, this button is used to synchronise them.
If one of the LumiPlus Flexi fails to respond to the COLOR/SEQUENCE commands, press the REFRESH button on the
LumiPlus Flexi and the last command will be sent so that it synchronises with the others.
- Selecting the speed of sequences
The -/+ buttons enable you to select one of the eight sequences, ordered from the slowest to the fastest speed.
- Switching LumiPlus Flexi Off
The LumiPlus Flexi are turned off by pressing the ON/OFF button. The status (colour/sequence) of the LumiPlus Flexi
is stored in the memory for the next time the system is switched on.
- Switching the remote control Off
The remote control automatically switches off in less than 60 seconds.
The LED display lights on the remote control only light up for a few seconds.
7.2 Control motion mode (see page 30)
When the control motion mode is switched on, the colours and sequences can be changed.
Changing the colour (Fig. A)
- Hold the remote control firmly without touching any of the buttons.
- Flick your wrist downwards.
- The change in colour will be displayed on the Central Display.
Changing the sequence (Fig. B)
- Hold the remote control firmly without touching any of the buttons.
- Flick you wrist form side to side.
- The change in sequence will be displayed on the Central Display.
8. CONTROL MOTION MAINTENANCE:
If the Central Display lights up in red without switching Off, this means the batteries are low. The battery case is on the
back of the Control Motion unit; replace the old batteries with two new AAA 1.5 V ones.
Red
Green
Blue
Yellow
Cyan
Blue
Yellow
Cyan Sky-blue
Green Orange
Pink Blue Pink
Green Cyan
Cyan Yellow
Blue Yellow
COLOUR Nº
7
8
9
10
11
12
ORDER OF COLOURS
Blue Pink
White Yellow Cyan
Cyan Magenta Pale
violet
4
COLOUR
Sky-blue
Pale violet
Orange
Pink
Emerald green
White
Magenta
Sky-blue Orange Pink Esmerald White
green