Friedrich Thru-the-Wall Serie Guide D'installation Et D'utilisation page 13

PROCEDURE A
If you are using the new sleeve supplied with
1
your unit, skip to step 3. Otherwise, install the
plastic grille from the kit. Cut the plastic grille to
25-1/2" wide and 15-1/4" high. Place the
plastic grille to the inside of the wall sleeve at
the rear flange.
Fasten the 4 washer screws to secure the grille
2
to the wall sleeve. If you need plastic nuts to
mount plastic grille to the inside of the wall
sleeve, there are plastic nuts in the installation
kit. The nuts are installed from the inside of the
sleeve and are pressed into the square holes of
the rear flanges.
or
Remove the backing from the Horizontal
3
Insulation strip 1 3 / 8 " x
that to the inside bottom of the sleeve as shown
below. Remove the backing from the Around
Insulation strip 1 3 / " x
8
that to the inside front of the sleeve as shown
below.
Around Insulation
Horizontal Insulation
All manuals and user guides at all-guides.com
FIG. 4
FIG. 5
5 / 8 " x 27 3 / 16 " and attach
3 / " x 61 1 / " and attach
4 2
FIG. 6
Install the new unit into the wall sleeve.
4
To assemble trim, snap the tab of each piece
5
into the slot of the other piece as shown below.
Slide trim over the front of the air conditioner
until trim is flush with sleeve as shown below.
Trim (2 ea)
Wall
CAUTION
• Air conditioners covered in this manual pose
an excessive weight hazard. Two or more
people are needed to move and install the unit.
To prevent injury or strain, use proper lifting
and carrying techniques when moving unit.
• When handling the air conditioner, be careful
to avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
13
FIG. 7