D-Link DES-1316 Guide D'installation Rapide page 9

Les langues disponibles

Configuring the Switch

The 8-Port 10/100Mbps Ethernet Web Smart Switch with 8-Port PoE has a Web GUI

interface for smart switch configuration. The Switch can be configured through the Web

Browser. A network administrator can manage, control, and monitor the Switch from the

local LAN. This section indicates how to configure the Switch to enable its smart

functions including:

Port Settings (Speed/Duplex and Flow Control)

VLAN Settings (802.1Q VLAN)

Trunking

Port Mirroring

PoE Settings

System Settings

Device status and Statistics

Before you configure this device, note that when the Web Smart Switch is configured

through an Ethernet connection, the manager PC must be set on same the IP network.

For example, when the default IP address of the Web Smart Switch is 192.168.0.1, then

the manager PC should be set at 192.168.0.x (where x is a number between 2 and 254),

and the default subnet mask is 255.255.255.0.

Open Internet Explorer 5.0 or above Web browser.

Enter the IP address http://192.168.0.1 (the factory-default IP address setting) into the

address location. (Figure 2.)

All manuals and user guides at all-guides.com

Figure 2.