D-Link DES-1316 Guide D'installation Rapide page 3

All manuals and user guides at all-guides.com
Connecting Network Cables
The DES-1316 supports 16 10/100M Ethernet ports and Port 1 ~ Port 8 are PoE
enabled ports. These PoE ports are automatically activated when a compatible terminal
is identified; the Switch will supply power through the Ethernet port to the connected
PoE device.
For Legacy devices that are not yet compatible, the PoE port will not offer power to this
device. This feature allows users to freely and safely mix legacy and Power over
Ethernet compatible devices on their network.
The Switch supports 10Mbps Ethernet or 100Mbps Fast Ethernet and it runs both in
half- and full- duplex mode using two pair of Category 5 cable.
These RJ45 ports are Auto-MDI type ports. The Switch can auto transform to MDI-II or
MDI-X type, so you can make an easy connection without worrying if you are using a
standard or crossover RJ45 cable.
AC Power
The Switch uses a 100-240V AC, 50-60 Hz power supply. The power switch is located at the rear
of the unit adjacent to the AC power connector and the system fan. The Switch's power supply will
adjust to the local power source automatically and may be turned on without having any or all LAN
segment cables connected.
3