Auto Mode - Adam Hall Cameo CLBARL10RGBIR Manuel D'utilisation

OPERATION / BEDIENUNG / UTILISATION / OPERACIÓN / OBSŁUGA / UTILIZZO
EN
INTERNAL PROGRAMS
Press the MODE button repeatedly until one of the 13 internal programs appears on the display (PGxx):
PG00 PROGRAM COLOUR MACROS + STROBE
Using the UP and DOWN buttons, select the PG00 program. To change the colour, press ENTER and select one of the seven available colours or
blackout by using the UP and DOWN buttons.
C- -0 = Blackout (LEDs off)
C- -1 = Red
C- -2 = Green
C- -3 = Blue
C- -4 = Cyan
C- -5 = Yellow
C- -6 = Magenta
C- -7 = White
Confirm with ENTER. The display now shows "FSxx". Now you can use the UP and DOWN buttons to add a strobe effect to the previously selected
colour. "FS00" stands for stroboscope effect disabled, "FS01" for the slowest and "FS99" for the fastest flash frequency. Once the desired
stroboscope effect has been set, press ENTER to confirm the input.
PG01 - PG12 COLOUR CHANGE PROGRAMS + STROBE
Using the UP and DOWN buttons, select one of the 12 colour changing programs PG01 - PG12.
In the programs PG01 - PG12 different colours (red, green, blue, cyan, yellow, magenta, white) are activated in turn with each other. The individual
colours can spread over the entire width of the LED bar, or be displayed in the 3 LED sections of the LED bar. The colour change occurs abruptly, and
the colours are blended into each other. The speed of the programs is separately adjustable and a stroboscope effect can also be activated.
Adjusting the speed and the stroboscope
Once you have selected one of the 12 programs, press ENTER to confirm. At the same time, the display changes to „SPxx" (Speed). Now you can
adjust the speed as desired by using the UP and DOWN buttons (SP01 = slowest, SP99 = fastest speed).
In order to both confirm and activate the strobe effect, press ENTER again and the display will change to „FSxx". Using the UP and DOWN buttons,
you can now set the stroboscope speed (FS00 = strobe disabled FS01 = slowest and FS99 = fastest flash frequency). Once the desired stroboscope
effect has been set, press ENTER to confirm the input.

AUTO MODE

Press the MODE button repeatedly until „AUTO" appears on the display. This mode combines the internal colour change programs, that is, the
programs PG01 to PG12 are automatically activated in sequence.
16