Sauder Cannery Bridge Serie Instructions D'installation page 27

Step 22
1
D26
Groove
Insert the DRAWER SIDES (D26 and D27) at an angle
å
into the slot at each end of the DRAWER FRONT (N).
3
Be sure the
DRAWER
BOTTOM inserts
into the DRAWER
BACK groove.
Fasten the DRAWER BACK (D150) to the DRAWER SIDES (D26 and D27). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D702) inserts into the groove of the DRAWER BACK (D150).
å
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D27
N
D150
D702
D26
VIEW THE T-LOCK BOX VIDEO
2
D26
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D702) into the grooves in the
å
DRAWER SIDES (D26 and D27) and DRAWER FRONT (N).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D27
424193
With the palm of
your hand, tap
the DRAWER
U n BOTTOM down
fi n
s u into the groove.
i s h
r f a
e d
c e
D702
D27
N
30S
(4 used in this step)
Page 27