Sauder Cannery Bridge Serie Instructions D'installation page 26

Step 21
1
D28
O
Groove
Insert the FILE DRAWER SIDES (D28 and D29) at
å
an angle into the slot at each end of the FILE
DRAWER FRONT (O).
3
Be sure the
DRAWER
BOTTOM inserts
into the DRAWER
BACK groove.
Fasten the FILE DRAWER BACK (D151) to the FILE DRAWER SIDES (D28 and D29). Use four BLACK 1-9/16" FLAT
å
HEAD SCREWS (30S).
NOTE: Be sure the FILE DRAWER BOTTOM (D954) inserts into the groove of the FILE DRAWER BACK (D151).
å
Page 26
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D29
D151
D28
D954
D29
VIEW THE T-LOCK BOX VIDEO
2
D28
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the FILE DRAWER BOTTOM (D954) into the
å
grooves in the FILE DRAWER SIDES (D28 and D29)
and FILE DRAWER FRONT (O).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
424193
With the palm of
your hand, tap the
DRAWER BOTTOM
U n fi
down into the groove.
n i s h
s u r
e d
f a c
e
D954
D29
O
30S
www.sauder.com/services