Uline H-6743 Mode D'emploi page 3

2
Bottom End of Locker
2
4
PAGE 3 OF 12
ASSEMBLY
1
Figure 1
4
5
Figure 2
7
6
Figure 3
ASSEMBLING MAIN PANELS
NOTE: Do not tighten bolts until unit is
completely assembled.
1. Place back (1) on a protected flat surface so that
the flanges face upward.
2. Bolt side (2) to back (1) so that side flange fits
around back (use 8 bolts and nuts - nuts to the
inside). Do not use bottom two holes; these will be
used for attaching legs in step 6. (See Figure 1)
3. Next, bolt top (4) and bottom (4) to back and left
side panel (use 4 bolts and nuts each). Bolt shelf (5)
to left side panel (use 2 bolts and nuts). (See Figure 2)
4. Bolt right side to the back so that side flange fits
around back. Attach side to top, bottom and shelf.
(See Figure 3)
5. Attach coat hooks (6 and 7) to locker's left and right
side, back panel and ceiling:
• Side/Back – 1 single hook (6) on sides and back of
locker, 1st and 2nd holes below shelf.
(See Figure 3)
• Ceiling – 1 double hook (7) on inside ceiling of
locker. (See Figure 3)
0823 IH-6743