Télécharger Imprimer la page

Worx WG368E Notice Originale page 14

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 42
SymboLS
WARNING
To reduce the risk of injury, user
must read instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Do not expose to moisture.
Do not expose to rain or water
Do not burn
14
Do not dispose of batteries. Return
exhausted batteries to your local
collection or recycling point.
This product has been marked
with a symbol relating to removing
electric and electronic waste. This
means that this product shall not
be discarded with household waste
but that it shall be returned to a
collection system which conforms
to the European Directive 2002/96/
CE. It will then be recycled or
dismantled in order to reduce the
impact on the environment. Electric
and electronic equipment can be
hazardous for the environment and
for human health since they contain
hazardous substances.
Cordless Chain Saw
All manuals and user guides at all-guides.com
INTENDED uSE
The chain saw is intended for sawing of trees,
tree trunks, branches, wooden beams, planks,
etc. Cuts can be sawed with or across the
grain. This product is not suitable for sawing
mineral materials.
ASSEmbLy
adjustments, make sure that the tool is
switched off and the battery is removed.
Always use gloves when handling the
chain.
ChAIN AND guIDE bAR ASSEMbLy
1. Unpack all parts carefully.
2. Place the chain saw on any suitable flat
3. Use only genuine WORX chains designed
4. Slide the Chain (8) in the slot around the
5. Fit the Chain onto the Drive Sprocket
6. Check to see if all parts are seated properly.
7. Fit the Chain Cover (11), ensure that the
8. Tighten the Chain Cover (11) by turning the
applies as described under "Tensioning
chain". The chain now needs to be
inspected to make sure it is properly
tensioned.
wARNINg! before touching
the chain or making any other
surface.
for chainbar.
Guide Bar (7). Ensure the Chain is in correct
running direction by comparing it to the
Chain Direction Symbol (13) found on
the saw body (See Fig. B). Ensure the Bar
Tensioning Plate (17) is facing outward.
(See Fig. A)
(12), so that the Fastening Bar Bolt (16)
and the two Bar Locating Tabs (14) on the
Bar Clamp (20) fit into the keyway of the
opening on the Guide Bar (7). (See Fig. B)
(See Fig. C)
Chain Catch (19) slides properly into the
Chain Cover (11). (See Fig. D)
Chain Tensioning Knob (10) clockwise until
it is tight. (See Fig. E)
wARNINg: The chain is not yet
tensioned. Tensioning the chain
En

Publicité

loading

Ce manuel est également adapté pour:

Wg368e.9