Publicité
Les langues disponibles
Les langues disponibles
20
C-21
C-22
C-23
C- 24
C-25
o
o
o
o
o
ON means the quartz tubes keep working. When the heater was set in ON
status, if the heater was overheat and show E3, we need unplug the plug,
wait for the temperature cool down, then plug in before restarting it.
Temperature unit convert function: When the heater is on, press and hold
the Power Button for 5 seconds, current temperature unit display will flash 3
timers and convert to another temperature unit (Note: Temperature unit
convert function can't be set with the remote control).
Lock & unlock heater function: press and hold the Heater Button for 10
seconds, the ember bed will flash 6 times, indicating that the heater function
is locked. To unlock the heater function, just repress and hold the heater
icon for 10 seconds again, then the ember bed will also flash 6 times
indicating the heater function is unlocked and to recover the original states
which you have set.(Note: Lock & unlock heater function can't be set with the
remote control)
TIMER
The TIMER has adjustable setting at range from 1 hour to 8 hours and OFF.
As shown the following: 1h-2h-3h-4h-5h-6h-7h-8h-OFF. If the digital display
turns on and nothing happens within 10 seconds, the digital display will auto
shut off. Once you have set the timer, and the timer is up, close all the
functions and enter standby mode. In this mode, you should touch the
power icon to restart the appliance.
INCREASE/DECREASE BUTTON
With the heater on, press the Increase/Decrease button to change the
desired temperature.
There are 11 temperature settings: 82
66
F-68
F-70
F-72
F-74
F-76
o
o
o
o
o
o
20
C-21
C -22
C-23
C- 24
C-25
o
o
o
o
o
12
C-26
C).
o
o
F-ON - 64
F-
o
o
F-78
F-80
F (27
C-ON - 18
C-19
C-
o
o
o
o
o
C-26
C)
o
o
BATTERIES REPLACEMENT
NOTE:
● Do not mix old and new batteries.
● Do not mix alkaline, standard (carbon zinc), or rechargeable (nicad, nimh,
etc.) batteries.
● Do not ingest batteries.
CAUTION:
● Always purchase the correct size and grade of battery most suitable for the
intended use.
● Replace all batteries of a set at the same time.
● Clean the battery contacts and also those of the device prior to battery
installation.
● Ensure the batteries are installed correctly with regard to polarity (+ and -).
● Remove batteries from equipment which is not to be used for an extended
period of time.
● Remove used batteries promptly.
TROUBLESHOOTING
Fault
Fault Cause
code
The heater
E1
overheating
E2
NTC is defective.
E3
The heater
not working.
Solution
Ask qualified technician for help.
Ask qualified technician for help.
If the vents are dirty or clogged.
Unplug the power, clean the dust and
debris of the vent area. Wait for 5
minutes, plug in and turn on the
heater. If the heater still don't work,
please ask qualified technician for help.
13
Publicité
