Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTION
Position your completed mantel close to its final location. Make sure you can
access the back of the mantel as your electric fireplace appliance will be
installed from back.
Using a Phillips head screwdriver, remove the screws and the metal
mounting center opening.
Next unpack the electric fireplace appliance carefully. Position the appliance
behind the fireplace with front facing the wood mantel. With the help of an
adult assistant, lift the appliance and gently slide it into the opening in the
mantel. Make sure the appliance is centered left and right in the opening. Be
careful when placing appliance and adjusting, bottom of appliance could
scratch the finish of the base/hearth of your fireplace. Re-attach the
mounting brackets with the Phillips head screwdriver, and supplied screws.
≥ 1.5"
ELECTRIC
FIREPLACE
INSERT
≥ 1"
≥ 1"
（A）
DO NOT OVER TIGHTEN. With the help of an assistant, carefully lift
completed unit and place it with the front facing out in the final location you
have chosen for your fireplace. Make sure to secure the electrical cord
before lifting or moving completed fireplace. When choosing a final location,
make sure you will have clear access to grounded electrical outlet.
06
ELECTRIC
FIREPLACE
INSERT
≥ 1.5"
≥ 1"
≥ 1"
（B）
REAR VIEW OF FIREPLACE
Grounding Pin
Cover of Grounded Outlet Box
Adapter
Grounding Lug
Metal Screw
Cover of Grounded Outlet Box
GROUNDING INSTRUCTIONS:
This heater is for use on 120 volts. The cord has a plug as shown at (A) in
figure 2. An adapter as shown at (C) is available for connecting three-blade
grounding-type plugs to two-slot receptacles. The green grounding lug
extending from the adapter must be connected to a permanent ground such
as a properly grounded outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
NOTE: Adapters are NOT for use in Canada
ELECTRICAL SPECIFICATIONS
Voltage: 120VAC 60Hz
Watts: 1500 Watts
Figure 2
A
B
C
07
Publicité
