Publicité
Les langues disponibles
Les langues disponibles
8622979
A loose track can slip off the driving wheel. This can cause a hazardous
situation or damage to the equipment. Check the track's tightness on a
regular basis.
1.
Set the machine on a flat surface of asphalt,
stone or pavement. Compact ground is also
acceptable.
2.
Lift the machine and set it on blocks or
supports rated for the weight of the
machine, so that the tracks are
approximately 4 in (100 mm) off the
ground.
3.
Measure the track midline vs. the horizontal
line. The reading must not be more than
10-15 mm. If the distance is greater,
proceed as follows (Fig. 5).
a.
Tip the dump box and set it on blocks or supports capable of holding
the weight of the box.
b.
Loosen locknut A.
c.
Tighten bolt B until the correct tightness is restored to the track.
d.
Secure bolt B by retightening locknut A to secure the bolt in place.
e.
Return the dump box to its original position.
NOTICE! Replace the track if the guide wheel axle (#71) is fully extended
forward and the track is still too loose.
REPLACING A TRACK
WARNING! Keep hands away from the track and wheels when under power to
avoid a crushing injury.
Check the condition of the tracks periodically. Replace a track that is cracked or
frayed.
1.
Set the machine on a flat surface of asphalt, stone or pavement. Compact
ground is also acceptable.
2.
Lift the machine and set it on jack stands or supports rated for the weight
of the machine. The tracks should be 4 in. (100 mm) off the ground.
10
All manuals and user guides at all-guides.com
660 lb Power Wheelbarrow
For technical questions call 1-800-665-8685
V 4.0
Fig. 5
Publicité
