Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
• If no key is pressed for 30 seconds, the clock will resume the alarm l display.
To set the ALARM 2
• Press and hold the
• Press and hold the
SET button for 3 seconds:
• The Alarm 2 hour digit will fl ash, then press the
• The Alarm 2 hour digit will fl ash, then press the
• The Alarm 2 hour digit will fl ash, then press the
to adjust to the desired hour.
• Press the
• Press the
SET button, the alarm2 minute digit will fl ash, then press
the
the
the
button or the
button or the
button or the
button to adjust to the desired minute.
button to adjust to the desired minute.
button to adjust to the desired minute.
• Press the
• Press the
SET button to show the current snooze
period with the minute fi eld fl ashes.
• Press the
• Press the
• Press the
button or the
button or the
button or the
period from 1 minute to 59 minutes.
• Press the
• Press the
SET button and the alarm2 time is set and enabled.
• If no key is pressed for 30 seconds, the clock will resume the alarm 2 display.
Using the Alarm and SNOOZE for daily ALARM 1 or ALARM 2
• Press the
• Press the
SET/
/
SET button to turn the alarm1 on, or the alarm1 off/ the alarm 2 on, or the
alarm2 off.
• When the current time reaches the alarm time that is enabled, the corresponding alarm is
activated.
• Press the
• Press the
SET/
/
SET button when the alarm is activated will stop the alarm for 24 hours.
• When the alarm is activated, press the SNOOZE • LIGHT button and the alarm stops but sounds
again after the snooze period (4 minutes snooze period is pre-programmed).
• The repeat alarm indicator will fl ash.
• The alarm will stop after 4 minutes if the
• The alarm will stop after 4 minutes if the
not pressed.
Receiving the radio control signal
The radio-controlled clock will automatically receive the radio signal every hour. It will take 3-5
minutes to receive the radio signal. If the DCF signal is received, the DCF tower will be visible on
the display, otherwise it will not.
Backlight
Press the SNOOZE • LIGHT button to light up the clock for 3 seconds.
Low battery level detection
Should the battery capacity drop to a level that is not suffi cient to operate the clock, the low
battery indicator will light up. The battery should be replaced as soon as possible.
Attention! Please dispose of used batteries in an ecologically safe manner.
10
button or the
button or the
button or the
button to adjust to the desired snooze
button to adjust to the desired snooze
button to adjust to the desired snooze
/
SET button or SNOOZE • LIGHT button is
SET/
button
button
button
Publicité
