Publicité
Les langues disponibles
Les langues disponibles
30
PROBLEM
Burner burns with a yellow or
orange flame, in conjunction
with the smell of gas.
Burners do not light.
-or- Burners have a small
flickering flame in the HIGH
position. -or- Barbecue
temperature only reaches
250˚ to 300˚ in the HIGH
position.
Burner does not light, or
flame is low in HIGH position.
Experiencing flare-ups:
m CAUTION: Do not line the
bottom tray with aluminum
foil.
Burner flame pattern is
erratic. Flame is low when
burner is on HIGH. Flames do
not run the whole length of
the burner tube.
Inside of lid appears to be
"peeling." (Resembles paint
peeling.)
If problems cannot be corrected by using these methods, please contact the
Customer Service Representative in your area using the contact information on
our web site. Log onto www.weber.com
All manuals and user guides at all-guides.com
troubleshooting
Inspect Spider / Insect
Screen for possible
obstructions. (Blockage of
holes.)
The excess flow safety
device, which is part of
the barbecue to cylinder
connection, may have
activated.
Is LP fuel low or empty?
Is fuel hose bent or kinked?
Does the Left burner light
with a match?
Are you preheating
barbecue in the prescribed
manner?
Is the cooking grate heavily
coated with burned-on
grease?
Is the burner clean?
The lid is cast aluminum,
not paint. It cannot "peel" .
What you are seeing is
baked on grease that has
turned to carbon and is
flaking off. THIS IS NOT A
DEFECT.
CHECK
.
®
CURE
Clean Spider / Insect
Screen. (See Section "Annual
Maintenance")
To reset the excess flow safety
device turn the burner control
knobs and the cylinder valve
OFF. Disconnect the adapter
from the cylinder. Turn burner
control knob to HIGH. Wait at
least 1 minute. Turn burner
control knob OFF. Reconnect
the adapter to the cylinder.
Turn cylinder valve on slowly.
Refer to "Lighting Instructions" .
Refill LP cylinder.
Straighten fuel hose.
If you can light the Left burner
with a match, then check the
Crossover
ignition system.
®
All burners on high for 10 to 15
minutes for preheating.
Clean thoroughly. (See Section
"Cleaning")
Clean burner. (See Section
"Maintenance" . )
Clean thoroughly. (See Section
"Cleaning" . )
Publicité
