Oregon Scientific RGR126N Mode D'emploi page 7

1. Insert the batteries, matching the polarity (+/-) as
shown in the battery compartment.
2. Press RESET, or press and hold SEARCH on the
main unit to initiate operation. The reception icons
( and ) on the main unit will blink while it is
searching for the sensor or rain gauge.
NOTE The main unit returns to default settings in each
battery replacement.
REMOTE SENSOR - INSERT BATTERIES
1. Remove the battery compartment cover by screw driver.
2. Insert the batteries, matching the polarities (+/-).
3. Press RESET after each battery change.
LOCATION
Rain collector sensor
Rainfall area
batteries low
Outdoor temperature area Outdoor sensor batteries low
Clock area Main unit batteries low
RGR126N_UM_EN_R13.indd 6
All manuals and user guides at all-guides.com
NOTE Use alkaline batteries for longer usage and consumer
grade lithium batteries in temperatures below freezing.
REMOTE SENSOR
The main unit can collect data from up to two (2) sensors,
including one rain gauge and one outdoor thermo sensor.
To set up the sensor:
1. Open the battery compartment.
2. Select a channel then press RESET.
3. Close the battery compartment cover.
4. Place the sensor within 100 m (329 ft) of the main
TIP For accurate readings, ideal
placements for the sensor would
be in any location on the exterior
of the home at a height of no
more than 1.5 m (5 ft); and can
shielded it from direct sunlight or
wet conditions.
SENSOR DATA TRANSMISSION
MEANING
To search for a sensor:
•
•
6
unit using the table stand or wall mount.
Press and hold SEARCH.
The sensor reception icon in the remote sensor
area shows the status (see below).
150cm(5ft)
2016/9/23 下午 5:53
Th
many fa
different
RAIN G
The rain
rate and
can rem
The ma
within a
open are
The rain
one met
away fro
naturally