Gloria SteelMaster V5 Mode D'emploi page 17

RZ_Steelmaster_NEUTRAL.qxp_Text_GB Professional Sprayers 27.04.20 15:50 Seite 17
4 Technical data
General
High-performance sprayers: Professional - Sprayer 5 l, Professional - Sprayer 10 l
Permissible positive operating pressure: 6 bar / Permissible operating temperature: 0°C to +50°C /
Full pressure change (0-6 bar) for max. 5000 load changes / Spray pipe holder / Pressure relief
valve / Pressure gauge / Flat spray nozzle: 80° / Max. output: 1 l/min / Reaction force on the noz-
zle: < 5 N / Pump material: steel, plastic / Mesh size of filter in quick closure valve: 0.9 mm / Resid-
ual quantity following horizontal emptying: none
Individual
High-performance sprayers
Max. filling capacity in litres
Total container content in litres 8
Empty weight in kg
Container material:
- Steel, internally coated
Special accessories: see figure on page 2
5 Assembly >>
6 Commissioning
WARNING
WARNING
ing components may result in draining or spouting of spraying agent. You should therefore
observe the following safety instructions:
 Prior to each use, check the device to ensure fault-free condition and leak-tightness.
To perform the leak test, fill the container with water!
 Inspect all screw joints for tight fitting.
6.1 5/10 litre devices >>
figures
6.1.2 Venting the container, draining the water and filling with spraying agent
figures
ATTENTION
 Activate the safety/vent valve – red button – until the device is depressurised.
 Prior to filling the sprayer, observe the instructions relating to particular hazards (R-phras-
es/German Hazardous Substances Ordinance [GefStoffV]) and safety advice (S-
phrases/German Hazardous Substance Ordinance [GefStoffV]) that are provided on the
chemical containers according to regulations.
 Observe max. fill level (see technical data). The regulations of the spraying agent manufac-
turer specify the correct dosage and concentration.
5 l 10 l
5 10
13,7
4,2 5,1
x x
4
1
–
figures
Before putting into operation, observe Chapter 2 "For your safety".
Danger to health due to escaping spraying agents! A leaking device or leak-
6.1.1 Inspecting the safety valve
5 6
–
7 10
–
17
>>