Beko WKD6246W Mode D'emploi page 8

3 Operation
3.1 Preparation
Clean kettle well before initial use and discard the
water of first two boiling cycles.
3.2 Operation
1. Push the lid release button (4) on the kettle to
open the lid (3).
2. Fill the water tank (7) with water.
C
Do not place the water tank (7) on
the base (8) while filling it with
water.
C
Never fill the water tank (7) above
the maximum level indicator or
below the minimum level indicator.
3. Close the lid (3) until it clicks into place.
4. Place the water tank (7) on the base (8). Make
sure that it is sitting in an upright and stable
position.
5. Insert the plug into the wall socket.
6. Select the desired temperature by pressing
the selection button (12). As the button (12)
is pushed the temperature selection will cycle
from 100 to 80, 60, 40 and back to 100 again.
– The temperature indicator light (13) will flash.
7. If desired, the simmer function can be activated
by pressing button (9).
– Indicator light of button (9) lights on.
When pressing the simmer function
C
button (9) in stand by mode without
selecting the desired temperature,
the indicator light of button (9) will
go off after 10 seconds.
8. Push On/Off button (10).
– Indicator light of On/Off button (10) lights on
and the boiling process begins.
8 / 68 EN
All manuals and user guides at all-guides.com
C
C
9. When the desired temperature is reached, the
C
C
10. Disconnect the plug from the wall socket.
11. Take the water tank from the base (8). Only
A
– When the appliance is in operation, indicator
light of the set temperature will flash.
Meantime, current water temperature will
be indicated by the relevant temperature
indicator light until the set temperature is
attained.
Lid (3) should always be closed
during the
otherwise the kettle will not switch
off automatically.
The desired temperature can be
changed or set during the boiling
process by pressing temperature
setting button (11).
indicator light of On/Off button (10) goes off
and the kettle stops operating.
– After 60 seconds the temperature indicator
lights (12) go off and the kettle returns into
stand by mode.
If you want to stop the boiling
process manually, push the On/Off
button (10).
If the simmer function is activated,
the kettle will restart the boiling
process when the temperature falls
below the desired temperature.
After 30 minutes, simmer function
will be cancelled automatically.
hold it by the handle (5).
WARNING: Do not open the lid
(3) as hot water could splash out.
Make sure that no water splashes
onto the base (8).
Kettle / User Manual
boiling process;