Functional Description; Dust/Chip Extraction - stayer TM6B Instructions D'emploi

Safety Warnings for Drills
- Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
- Use appropriate detectors to determine if utility
lines are hidden in the work area or call the local
utility company for assistance. Contact with electric
lines can lead to fire and electric shock. Damaging a
gas line can lead to explosion. Penetrating a water
line causes property damage or may cause an electric
shock.
- Switch off the power tool immediately when the tool
insert jams. Be prepared for high reaction torque
that can cause kickback. The tool insert jams when:
— the power tool is subject to overload or
— it becomes wedged in the workpiece.
- Hold the machine with a firm grip. High reaction
torque can briefly occur while driving in and loosening
screws.
- Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than
by hand.
- Keep your workplace clean. Blends of materials are
particularly dangerous. Dust from light alloys can burn
or explode.
- Always wait until the machine has come to a
complete stop before placing it down. The tool insert
can jam and lead to loss of control over the power tool.
- Never use the machine with a damaged cable. Do
not touch the damaged cable and pull the mains
plug when the cable is damaged while working.
Damaged cables increase the risk of an electric shock.

Functional Description

Read all safety warnings and all instructions.
Failur to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
While reading the operating instructions, unfold the
graphics page for the machine and leave it open.
Intended Use
The machine is intended for drilling in wood, metal,
ceramic and plastic. Machines with electronic control and
right and left rotation are also suitable for screwdriving.
ENGLISH
11
Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Keyless chuck
2 Front sleeve
3 Rear sleeve
5 Lock-on button for On/Off switch
6 On/Off switch
7 Rotational direction switch
Assembly
Changing the Tool
- Before any work on the machine itself, pull the mains
plug.
- Wear protective gloves when changing the tool. The
drill chuck can become very hot during longer work
periods.
Keyless Chuck (see figure A)
Hold the rear sleeve 3 of the keyless chuck 1 tight and turn
the front sleeve 2 in rotation direction
be inserted. Insert the tool.
Hold the rear sleeve 3 of the keyless chuck 1 tight and
firmly tighten the front sleeve 2 by hand in rotation direction
, until the locking action (click) is heard. The drill chuck
is locked automatically.
The locking is released again to remove the tool when the
front sleeve 2 is turned in the opposite direction.
Screwdriver Tools (see figure B)
When working with screwdriver bits 8, a universal bit
holder 9 should always be used. Use only screwdriver bits
that fit the screw head.
Replacing the Drill Chuck
For machines without spindle lock, the drill chuck must be
replaced through an authorized after-sales service agent
for Stayer power tools.
The drill chuck must be tightened with a tightening
torque of approx. 31–35 Nm.

Dust/Chip Extraction

Dusts from materials such as lead-containing coatings,
some wood types, minerals and metal can be harmful to
one's health. Touching or breathing-in the dusts can cause
allergic reactions and/or lead to respiratory infections of
the user or bystanders.
Certain dusts, such as oak or beech dust, are considered
as carcino genic, especially in connection with wood-
treatment additives (chromate, wood preservative).
11
until the tool can