GE 25833 Mode D'emploi page 40

3. Disconnect the cord attached to the battery pack from
the jack inside the battery compartment and remove the
battery pack from the handset.
4. Insert the new battery pack and reconnect the battery
plug.
5. Put the battery compartment cover back on.
6. Place handset in the base.
If you don't charge the handset battery properly (for 16
hours) when you first set up the phone and/or when
you install a new battery pack, the battery's long-term
performance will be compromised.
NOTE: If the battery is not properly installed in the handset, or if the battery
pack is not properly connected to the jack inside the battery compartment. "NO
BATTERY" shows in the display when the handset is placed in the charging cradle.
NOTE: If a battery is disconnected from the phone and then reconnected, the
phone must be placed in the base 2 minutes to allow it to reset.
Battery Safety Precautions
• Do not burn, disassemble, mutilate or puncture. Like other batteries of this type, toxic
materials could be released which can cause injury.
• Keep batteries out of the reach of children.
• Remove batteries if storing over 30 days.
Belt Clip and Optional Headset
Connecting the Belt Clip
1. To attach the belt clip, insert the sides of the belt clip into the slots on each side of the
handset.
2. Snap the ends of the belt clip into place.
Connecting an Optional Headset to the Handset
Each handset can be used with an optional headset for hands free operation.
1. Connect the headset to the headset jack on the side of the handset. The handset
receiver and microphone are disabled when the headset is connected.
2. Adjust the headset to rest comfortably on top of your head and over your ear. Move
the microphone to approximately two to three inches from your mouth.
3. Press theTALK•CALL BACK button to answer a call or make calls using the headset.
4. To return to normal operation, unplug the headset from the jack.
40
All manuals and user guides at all-guides.com
Battery
compartment
Battery pack
Battery pack
plug