Beta 1760DGT Mode D'emploi page 19

REPLACING THE FUSES
Warning: To avoid electric shock, disconnect the test leads from any source of voltage before
removing the fuse door.
1 Disconnect the test leads from the meter and any item under test.
2 Open the fuse door by loosening the screw on the door using a Phillips head screwdriver.
3 Remove the old fuse from its holder by gently pulling it out
4 Install the new fuse into the holder.
5 Always use a fuse of the proper size and value (0.5A/250V fast blow for the 400mA range,
20A/250V fast blow for the20A range).
6 Put the fuse door back in place. Insert the screw and tighten it securely.
Warning: To avoid electric shock, do not operate your meter until the fuse door is in place and
fastened securely.
Declaration of conformity (CE)
The product 1760DGT is in conformity with EMC directive 89/336/CEE emanated from the
Commission of the European Community.
All manuals and user guides at all-guides.com
19