Publicité
Precautions
• Do not continuously use the speaker system
beyond the peak power handling capacity.
• Keep recorded tapes, watches, and personal
credit cards using magnetic coding away
from the speaker system to protect them
from damage caused by the magnets in the
speakers.
• Please note the following when installing the
units; otherwise malfunction and/or
deterioration in sound quality may result.
- Do not touch the diaphragms and/or
speaker cones by hand or with tools.
- Do not put your fingers through the holes
of the frame.
- Do not drop foreign objects in the units.
• Do not place this product close to medical
devices.
- This product (including accessories)
has magnet(s) which may interfere with
pacemakers, programmable shunt valves
for hydrocephalus treatment, or other
medical devices. Do not place this product
close to persons who use such medical
devices. Consult your doctor before using
this product if you use any such medical
device.
If you cannot find an appropriate mounting
location, consult your car dealer
or
your
nearest Sony dealer before mounting.
Specifications
Speaker
Coaxial 2 way:
Woofer 16 cm
x
20 cm
(6 in
x
8 in) cone type
Tweeter 2.0
cm
(
13
/,5
in)
dome type
Short-term maximum power*
1
230 W*
2
Rated power
38 W*
2
CTA 2031 RMS Power
40 W
Rated impedance
4 Q
Output sound pressure level
90 dB± 2 dB (1 W, 1 m)*
2
Effective frequency range
45 Hz - 24 000 Hz*
2
Mass
Woofer: Approx
.
700 g
(1
lb
9
oz)
per speaker
Supplied accessories
Parts for installation
Design and specifications are subject to change without
notice.
*
1
"Short-term maximum
power"
may also be
referred
to as
"Peak
Power".
*
2
Testing Condition: IEC 60268-5 (2003-05)
Mounting/ Montage
Before mounting
A depth of at least 57.5 mm
(2
3
/
s
in) is required
to mount the woofer. Measure the depth
of
the area where you are to mount the speaker,
and ensure that the speaker is not obstructing
any other components of the car. Keep the
followings in mind when choosing a mounting
location:
• Make sure that nothing is obstructing around
the mounting location of the door
(front
or
rear) where you are to mount the speaker.
• A hole for mounting may already be cut
out
of the inner panel of the door
(front
or rear).
In this case, you need to modify the board
only.
• If you are to mount this speaker system in
the door
(front
or
rear),
make sure that the
speaker terminals, frame or magnet do not
interfere with any inner parts, such as the
window mechanism in the door (when you
open or close the
window),
etc.
Also make sure that the speaker grille does
not touch any inner fittings, such as the
window cranks, door handles, arm
rests,
door
pockets, lamps or seats etc.
• If you are to mount this speaker system in
the rear tray, make sure that the speaker
terminals, frame or magnet do not touch
any
inner parts of the car, such as the torsion bar
springs (when you open or close the
trunk
lid), etc.
Also make sure that the speaker grille does
not touch
any
inner fittings, su ch
as seat
belts,
head
rests,
center
brake
lights,
inner
covers
of the rear
wipers, curtains or air
purifiers, etc.
Publicité
